Multi Application Clips
Holds C7, C9, Mini Christmas Lights - 50 Pack
Shingle Tab Light Clips
For C7 or C9 Christmas Light Bulbs - 25 Pack$0.22 ea.Sold only by the 25 Pack for $5.62
All in One Flip Clip
Holds C7, C9, Icicle, and Mini Lights - 75 Pack$0.08 ea.Sold only by the 75 Pack for $6.23
For C7 Socket Light Strings - 25 Pack$0.57 ea.Sold only by the 25 Pack for $14.31
For C9 Socket Light Strings - 25 Pack$0.72 ea.Sold only by the 25 Pack for $17.98
The Multi Application clear light clip is the perfect accessory to hang your lighting sets this holiday season.
- Secondary hook holds any insulated electrical cord without damage
- Use flat bottom lights to have lights stand up straight
- Easily attachable to shingles, tile roofs, or gutters
|Brand||Christmas Lite Co.|
|MPN (Part No.)||CCH0501050102|
|Mounting||Shingles and Gutters|
|Use With||C7, C9, Swag, Tube, Icicle, Mini Lights|
- Begin by measuring the areas you want to decorate. Spacing on miniature light sets varies between two to three lights per foot. When using miniature light strings to create an icicle effect, the number of lights required per linear foot of roofline is determined by length of icicle "drop" you use. "Drops" averaging 18" in length and 6" apart, will require about 14 lights per linear foot of roofline. Remember to complete a "drop", the light string hangs down and must run back up. Estimate one clip per "drop".
- Locate your electrical outlets before installing lights. It's easiest to light a home by starting near the middle and running lights in both directions.
- Estimate the electrical requirements for your installation. The total current draw in amperes can be estimated by adding the current of all strings powered from a single outlet. The current rating of each light string should be marked on the product or on its packaging. The number of Christmas light strings you can connect will depend upon the capacity of the circuit in amperes, and what household loads are already connected to that circuit.
- To run electrical power long distances, use heavy extension cords. Use electrical cords of sufficient length to avoid stringing cords together. Try to anticipate areas where water or snow might accumulate and locate connections away from such areas. Connections are best located in sheltered areas, such as beneath overhangs. Be sure to secure cords against excessive movement due to wind, etc. Do not use any fastener that has the potential to damage the cord insulation. The secondary hook on the Lites, All-in-One PLUS Clips and Icicle Clips can be used for this purpose.
- Inspect and test your light strings prior to installation. Do not use light sets with cracked insulation or damaged cords. Replaced C7 and C9 lamps only with lamps of the same wattage as the original lamp, or in the case of miniature lights, lamps of the same voltage rating.